Sign In / Sign Up To Add Wishlist
Wishlist is available for members only. Please sign in or sign up to add your wishlist.
Support for CM900
- Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
- Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
- I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good. Show More Show Less
- The mat or the material catches on a feed roller during cutting/drawing.
- What should I do if the scanned and cut positions are misaligned?
- There are deep cuts completely through the mat.
- What should I do if the entire pattern is not cut?
- What should I do if part of the material is not cut?
- I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- Not all of the material to be cut is cut. Some areas remain uncut.
- The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- The mat is fed in at an angle and is not fed during cutting / drawing. Show More Show Less
Other FAQs Category
A guide to navigating our most common questions