Sign In / Sign Up To Add Wishlist
Wishlist is available for members only. Please sign in or sign up to add your wishlist.
Support for CM700
- About Blade Extension, Cutting Pressure and Mat
- Can different types of material be attached to the same mat for cutting?
- If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- Can rough material be cut?
- Can multiple sheets of material be overlapped and attached to the mat?
- Mat and Material Combinations
- I find some scratches outside the grid area (the attaching area) on the mat. Why is such a scratch attached on the mat?
- How long will the mat last?
- Mat and Cutting Blade Combinations Show More Show Less
- The mat or the material catches on a feed roller during cutting/drawing.
- The material to be cut/drawn or original to be scanned cannot be attached to the mat.
- The mat is fed in at an angle.
- The mat cannot be recognized.
- The mat cannot be inserted.
- If the blade cuts through the mat, can tape, etc., be attached to the back so the mat can be reused?
- Mat and Material Combinations
- Mat and Cutting Blade Combinations
- There are deep cuts completely through the mat.
- The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- The mat is fed in at an angle and is not fed during cutting / drawing.
- The mat or the material catches on a feed roller when the mat is being inserted.
- The mat cannot be fed.
- When the mat is inserted, the attached material peels off.
- The mat cannot be fed out. Show More Show Less
Other FAQs Category
A guide to navigating our most common questions